Store hours Rochester Appliance SALES · SERVICE · PARTS Visit our showroom (585) 272-9933
Repair & parts

The appliance parts Rochester replaces most, and which ones you can fix yourself

We sorted every failed part from nearly 40,000 Rochester service calls. The same short list of parts shows up again and again. Here they are, with the symptom that gives each one away and whether it's a DIY job.

Rochester Appliance parts counter with labeled parts bins on the shelves

The short version

  • A failed igniter is behind 1 in 3 range breakdowns our technicians find (33%).
  • On dryers, four wear parts show up in 4 of every 10 failures: the drive belt (19%), idler pulley (12%), drum rollers (11%) and thermal fuse (10%).
  • Oven igniters (1,647), dryer belts (1,555) and dryer thermal fuses (1,292) are the three parts we've sold most at our parts counter since April 2020.
  • Belts, pulleys, rollers, thermal fuses and electric bake elements are reasonable do-it-yourself repairs. Control boards, gas parts and sealed systems are jobs for a technician.

Since 2014 our technicians have written up nearly 40,000 service calls in Rochester and the surrounding towns. When we sorted every failed part they found, the same short list kept coming up, appliance after appliance and year after year. Here it is, with what each part does, the symptom that gives it away, and whether it's a job for you or for us.

Ranges and ovens: the igniter leads the list

On gas ranges the oven igniter is the most common failure we see on any kitchen appliance. As an igniter wears out it still glows, but it no longer gets hot enough to open the gas valve. The oven clicks or glows orange and then never lights, or it takes several minutes to start. The symptoms below point to the most likely part; your exact model's diagnosis confirms it.

Most common failed parts on ranges and ovens
PartShare of range failures
Igniter33%
Main control board11%
Surface element or burner6%
Bake element5%
Spark module or switch3%
3,030 range failures where a part failed, 2014 through September 2026. A failure can involve more than one part.
  • Gas oven glows but won't light: most often a weak igniter.
  • Electric oven won't heat, or the bottom element has a visible blister or break: the bake element.
  • One burner keeps clicking after it lights: spark switch, or moisture under the burner cap. Let it dry before you replace anything.
  • Electric burner on high only, or not at all: surface element or its infinite switch.

Dryers: belts, pulleys, rollers and the thermal fuse

Dryers fail mechanically far more often than electronically. The drum turns on a belt, the belt runs over an idler pulley, and the drum rides on rollers or glides. All of these wear out with use, and we sell a lot of them.

Most common failed parts on dryers
PartShare of dryer failures
Drive belt19%
Idler pulley12%
Drum rollers11%
Thermal fuse10%
Gas valve coils8%
Heating element7%
5,585 dryer failures where a part failed, 2014 through September 2026.
  • Motor hums but the drum doesn't turn: usually a broken belt. Check the idler pulley while you're in there.
  • Squealing, thumping or a rumble that gets louder: idler pulley or drum rollers. Replace them as a set.
  • Electric dryer runs but doesn't heat: first check that both breakers for the dryer are fully on and the cycle isn't set to air dry. Then the thermal fuse, then the heating element.
  • Gas dryer heats for a few minutes, then goes cold: usually the gas valve coils (a technician job).

Refrigerators: fans, ice makers and defrost

Most common failed parts on refrigerators
PartShare of refrigerator failures
Evaporator fan motor9%
Ice maker8%
Main control board8%
Door gasket or seal5%
Defrost thermostat or sensor5%
5,161 refrigerator failures where a part failed, 2014 through September 2026.
  • Freezer is cold but the fridge section is warm: evaporator fan motor, or a defrost problem blocking the airflow.
  • Chirping or squealing from the freezer that stops when you open the door: evaporator fan motor.
  • Frost building up on the back wall of the freezer: defrost thermostat, sensor or heater.
  • No ice, but water dispenses fine: often the ice maker itself. No ice and no water: often the water inlet valve or a frozen line.

Dishwashers: control boards and pumps

Most common failed parts on dishwashers
PartShare of dishwasher failures
Main control board12%
Wash motor or pump12%
User interface or control panel9%
Spray arm6%
Water inlet valve5%
2,917 dishwasher failures where a part failed, 2014 through September 2026.

Before you blame a part, clean the filter under the bottom rack. A clogged filter causes plenty of "not cleaning" and "not draining" calls where nothing is actually broken.

The parts we sell most at our parts counter

Parts sold at Rochester Appliance, April 2020 through September 2026
PartUnits sold
Oven and range igniters1,647
Dryer drive belts1,555
Dryer thermal fuses1,292
Burner drip bowls793
Bake elements788
Gas dryer valve coils502
Idler pulleys458
Ice makers420
Surface elements416
Dryer thermal cutoffs397

DIY or call us?

How hard each common repair is
RepairDifficultyOur advice
Dryer thermal fuseEasyDIY. Clean the vent at the same time.
Electric bake elementEasyDIY. Turn the power off at the breaker first.
Dryer belt, idler pulley, rollersModerateDIY in about an hour. Replace them together.
Gas oven igniterGas workCall us. We recommend a technician for gas parts.
Gas dryer valve coilsGas workCall us. We recommend a technician for gas parts.
Refrigerator evaporator fanModerateDIY if you can empty and open up the freezer.
Control boardsHard to diagnoseCall us. A board is expensive and often not the real cause.
Sealed system or compressorTechnician onlyCall us. This takes refrigerant tools and certification.

Bring your model number

The right part depends on the exact model, not just the brand. Look for the model tag inside the door frame on dryers and dishwashers, on the inside wall of a refrigerator, or behind the storage drawer on a range. Take a photo of it and bring it to our parts counter. If you'd rather not take it on yourself, schedule a repair and one of our technicians will diagnose it.

Find appliance partsSchedule a repair

Quick answers

What is the most common reason a gas oven won't light?

A worn igniter. It still glows but no longer gets hot enough to open the gas valve. Igniters cause 33% of the range and oven failures our technicians find.

Why does my dryer run but not heat?

On an electric dryer, first make sure both breakers are fully on and the cycle isn't set to air dry. Then check the thermal fuse and the heating element. On a gas dryer that heats briefly and then stops, the gas valve coils are the usual cause; have a technician replace them. A blown thermal fuse usually means the vent is clogged with lint, so clean the vent too.

Can I replace a dryer belt myself?

Yes. Most people can replace a belt in about an hour with basic hand tools. Unplug the dryer first, and replace the idler pulley at the same time if it's worn.

How we got these numbers

From Rochester Appliance's own records: 39,588 service orders (June 2014 through September 30, 2026) and parts sales from April 2020 through September 30, 2026.

  • Rochester Appliance service records: 39,588 service orders from June 2014 through September 30, 2026. Each technician's notes were read and every failed part recorded. Shares are the percentage of an appliance's failures that involved that part; one failure can involve more than one part.
  • Rochester Appliance parts sales, April 28, 2020 through September 30, 2026, counted in units sold.
← All posts